The pass-through kit (model 25974) can be used on the sides or back of flammable liquid safety cabinets. This unique system provides a means to dispense solvents with pressurized nitrogen through the wall of a cabinet, if a pressure nitrogen assist from an outside source is needed. It can also be used for vacuum or pressure venting containers inside the cabinet. The stainless-steel construction without a check valve allows flow in either direction. A ¼-in NPT (tapered) fitting is required to thread into both sides of the pass-through. Only install on the sides and back of the safety cabinet, never on the doors, bottom or top of a cabinet.
Factory installed—must be ordered with cabinet.
Note: This TechTALK has guidelines for ordering factory-installed pass-through kits for Justrite safety cabinets to maintain FM approval and our 10-year warranty.
Product Summary:
- Not valved
- All stainless-steel construction
- Regulated pressurized nitrogen cylinder pressurizes container inside cabinet to dispense solvent at low pressure out of cabinet
- Can be used for vacuum or pressure venting containers inside cabinets
- Factory installed and FM-Approved with purchased safety cabinet
Specifications
| Model No | 25974 |
|---|---|
| UPC | 697841008670 |
| International Model No. | 25974 |
| FM Approval | Yes |
| Net Weight, lbs | 0.8 |
| Net Weight, kg | 0.4 |
Documentation:
TechTALK - Safety Cabinets: Self-Close Door vs Manual (145.65 KB)
IFC Self-Close Door Requirements by State for Hazmat Cabinets (282.48 KB)
NFPA-1 Fire Code Self-Close Door Requirements by State for Hazmat Cabinets (195.85 KB)
IFC Self-Close Door Requirements by State for Flammable Cabinets (1.54 MB)
NFPA 30 & OSHA Self-Close Door Requirements by State for Flammable Cabinets (299.25 KB)
Pass-Through Instruction Guide (527.77 KB)
